We buy surplus electrical cable in Cedar Park
Cedar Park surplus is control cable, drive cable and the occasional emergency feeder. It arrives in small quantities, it carries a shield, and it needs a buyer who reads the jacket print.
Send the lot
Six details are enough to start: what the cable is, how much there is, where it is and what condition it is in. Photos can follow by text or email.
Prefer to talk 954-740-1983Precision machining and medical offices do not produce the same surplus as a warehouse. There are no pallets of feeder on the racking. There are coils of control cable, a partial reel of VFD cable, shielded instrumentation pairs, and the emergency feeder that came out of a surgery suite.
That material is worth reviewing on its own terms. A scrap yard reads weight and metal. We read the shield, the conductor count, the temperature rating and the jacket print, because those four facts decide whether a length can go back into a panel or a drive cabinet.
Control and drive cable from a machine move
When a line is reconfigured, the cable usually comes off with the machine. VFD cable, motor leads, encoder and instrumentation runs, often cut at the cabinet rather than disconnected at the terminals. Lengths are short, and the conductor counts and shield types are specific to the machine.
We ask for the conductor count, the gauge, the shield type and the jacket print. A twelve conductor eighteen gauge is not interchangeable with a four conductor sixteen, and a buyer told only that it is control cable will have to ask twice.
Shielded, unshielded and the drain wire
A foil shield with a drain wire, a braid, or both, changes how a length is reviewed. Shielded cable for drives and instrumentation holds its value better than unshielded control cable, because the shield is the reason it was specified.
Look at the cut end before you photograph it. If the shield is cut back and the drain wire is gone, say so. If the jacket print names the shield type, photograph that instead. The review turns on those two facts more often than on footage.
Emergency feeders and 183A office park re-fits
Medical office and surgery center re-fits along the 183A corridor bring a different class of surplus. Emergency power feeders, transfer switch cable and the branch circuits that served equipment being replaced. Some of it is large conductor in short runs.
Interior build-outs in the same office parks produce MC and AC in quantity, often in new condition and still bundled. Keep the two streams apart in your submission. Emergency feeders are reviewed for reuse on conductor and insulation, MC on length and armor.
What this page covers
The rows a buyer would fill in when reviewing this kind of lot. If your cable matches most of them, the submission is ready.
| County | Williamson County |
|---|---|
| Corridors | 183A, RM 620, Lakeline Boulevard |
| Typical stock | Control, VFD, tray, MC, emergency feeder |
| Lot size | Single coils to a pallet |
| Condition focus | Shield type, jacket print, cut ends |
| Pickup notes | Forklift access helps, not required |
183A, the medical mile and a small specialty lot
Cedar Park runs along 183A from the RM 620 interchange up toward Leander, with the medical and office parks sitting between the toll road and the old highway. Buildings here are new, so surplus is usually from a move or a re-fit rather than a demolition.
Small quantity specialty cable is where a general scrap buyer struggles, and that is the lot we want to see. Twenty feet of shielded drive cable, forty feet of tray, a partial of instrumentation. Send it as one submission, with the jacket prints.
Sellers ask
Do you take twenty feet of shielded control cable?
Yes. Small specialty lengths are reviewed on conductor count, gauge, shield type and jacket print. A single coil is enough to start. What we cannot do much with is a length with no print and no shield left at the end.
How do I tell foil shield from braid shield?
Cut back two inches of jacket and look. Foil is a thin metallic film, usually with a bare drain wire laid against it. Braid is a woven mesh. Photograph the cut end in daylight and the difference is obvious.
Can you collect from a machine works with a forklift only?
Often yes. Tell us the door height, the forklift capacity and whether the coil can be palletized. Coils of control cable are light but awkward, and a pallet with a strap around it moves faster than a loose coil in a truck bed.
Is emergency feeder from a clinic re-fit worth submitting?
It can be. Emergency feeders are usually copper and often in good jacket condition, since they were installed indoors and never buried. Send the conductor size, the insulation type and the length. How the cable was supported matters more than age.
Send the reel list
Six details are enough to start: what the cable is, how much there is, where it is and what condition it is in. Photos can follow by text or email.
Prefer to talk 954-740-1983